• Code: E602-0002
• Description: Firmware error
• Causes: Loading of Bootable ends in failure.
• Remedy: 1. Reinstall the firmware. 2. Replace the Main Controller PCB.

• Code: E602-0003
• Description: SD Card access error
• Causes: Error caused by hardware (such as damage on the sector, etc.) occurred when accessing to the SD Card during execution of Boot ROM
• Remedy: 1. Turn OFF and then ON the main power. 2. Back up data, and format the SD Card. 3. Replace the SD Card. 4. Replace the Main Controller PCB.

• Code: E602-0006
• Description: Firmware error
• Causes: Loading of Subbootable ends in failure.
• Remedy: 1. Reinstall the firmware. 2. Replace the Main Controller PCB.

• Code: E602-0007
• Description: Firmware error
• Causes: Damage on the internal file
• Remedy: 1. Reinstall the firmware. 2. Replace the Main Controller PCB.

• Code: E602-0008
• Description: The memory area in the Main Controller is depleted.
• Causes: Remaining memory area in the Main Controller is small.
• Remedy: * Turning OFF and then ON the main power stops the error code to be displayed, but the continuous use causes the memory area in the Main Controller PCB to be completely used up or causes symptoms such as machine freeze. 1. Replace the Main Controller PCB.

• Code: E602-0009
• Description: MEAP cannot be started.
• Causes: MEAP cannot be started due to an error caused by invalid power down.
• Remedy: Select Function.gr > MEAP > MEAP FUNCTION = ON, and turn OFF and then ON the main power. * Since the installed MEAP application and its management information are all cleared after reboot, MEAP needs to be reinstalled.

• Code: E602-1102
• Description: File system could not be initialized normally (MEAPrelated).
• Causes: File system could not be initialized normally (MEAP-related).
• Remedy: Turning OFF and then ON the main power executes auto recovery. Since E616-0001 may be displayed in some cases, execute the remedy for E616-0001. * When this error occurs, the firmware downloaded by the CDS Updater will be lost.

• Code: E602-1112
• Description: Device access error (MEAP-related)
• Causes: Device access error (MEAPrelated)
• Remedy: Turning OFF and then ON the main power executes auto recovery. Since E616-0001 may be displayed in some cases, execute the remedy for E616-0001. * When this error occurs, the firmware downloaded by the CDS Updater will be lost.