• Code: E719-0011
• Description: Coin vendor error
  Error when the NewCardReader is started
  - The NewCardReader, which must have been connected before the power was turned OFF, is not connected when the power is turned ON.)
• Remedy: Check cable connection between the charging management equipment and the host machine.
  While the charging management equipment is connected for operation, clear the error in the case of switching to the operation without the charging management equipment.
  (To prevent a misuse by removing the charging management equipment, this error code is displayed.)

• Code: E719-0012
• Description: Coin vendor error
  IPC error at NewCardReader operation
  Open circuit of IPC, unable to recover the IPC communication
• Remedy: Check cable connection between the charging management equipment and the host machine.
  While the charging management equipment is connected for operation, clear the error in the case of switching to the operation without the charging management equipment.
  (To prevent a misuse by removing the charging management equipment, this error code is displayed.)

• Code: E719-0031
• Description: Serial communication error when the NewCardReader is started
  Unable to start communication with the Serial NewCardReader at startup
• Remedy: 1. Check if the cable of Serial NewCardReader is open circuit.
  2. Remove the Serial NewCardReader.
  COPIER > Function > CLEAR > CARD
  COPIER > Function > CLEAR > ERR

• Code: E719-0032
• Description: Serial communication error after the NewCardReader was started
  Although communication with the Card Reader was possible at startup, it became unavailable in the middle of communication
• Remedy: Check if the NewCardReader cable is open circuit

• Code: E730-1001
• Description: PDL software erro
  rInitialization error
• Remedy: 1. PDL reset processing (user mode > function settings > printer > printer settings > utility > Reset Printer).
  2. Turn OFF and then ON the power.

• Code: E730-100A
• Description: PDL software error
  Systematic fatal error occurs
• Remedy: 1. PDL reset processing (user mode > function settings > printer > printer settings > utility > Reset Printer).
  2. Turn OFF and then ON the power.

• Code: E730-A006
• Description: PDL communication error
  No reply from PDL. No reply from PDL due to failure or absence of the controller firmware
• Remedy: 1. PDL reset processing (user mode > function settings > printer > printer settings > utility > Reset Printer).
  2. Turn OFF and then ON the power.
  3. Check connection of Main Controller PCB.
  4. Reinstall the controller firmware.
  5. Replace Main Controller PCB (PCB2).

• Code: E730-A007
• Description: Mismatched PDL version
  Mismatch in version of the control software between the host machine and the PDL.
• Remedy: System all format and installation.