• Code: E719-0011
• Description: Error when the Card Reader is started
  The Card Reader which was connected before turning OFF the power is not connected at power-on.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0012
• Description: IPC error at Card Reader operation
  Open circuit of IPC, unable to recover the IPC communication.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0031
• Description: Communication error when the Card Reader (serial) is started
  Unable to start communication with the Card Reader at startup.
• Remedy: 1. Check the cable connection of the Card Reader (connector connection error, open circuit), and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR. 2. After removing the Card Reader, execute the following service mode, and then reinstall the Card Reader. • COPIER>FUNCTION>CLEAR>CARD • COPIER>FUNCTION>CLEAR>ERR"

• Code: E719-0032
• Description: Communication error after the Card Reader (serial) is started
  Although communication with the Card Reader was possible at startup, it became unavailable in the middle of it.
• Remedy: Check the cable connection of the Card Reader (connector connection error, open circuit), and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E730-1001
• Description: PDL software error
  Systematic fatal error, such as initialization failure, occurs.
• Remedy: 1. PDL reset processing. 2. Turn OFF and then ON the power.

• Code: E730-100A
• Description: PDL software error
  Systematic fatal error, such as initialization failure, occurs.
• Remedy: 1. PDL reset processing. 2. Turn OFF and then ON the power.

• Code: E730-9004
• Description: Third party PDL communication error
  Communication error with the print server.
• Remedy: 1. Turn OFF and then ON the power. 2. Check the cable connection. 3. Replace the Open I/F PCB, F Link PCB (Main/Sub). 4. Replace the Main Controller PCB.

• Code: E730-9005
• Description: Third party PDL communication error
  Error in video cable connection with the print server.
• Remedy: 1. Turn OFF and then ON the power. 2. Check the cable connection. 3. Replace the Open I/F PCB, F Link PCB (Main/Sub). 4. Replace the Main Controller PCB.