• Code: E024-0001
• Description: Detection of disconnection of the Developing Assembly Toner Sensor (TS2)
  At normal speed: Developing Assembly Toner Sensor (TS2) signals were detected 7500 times in a row at intervals of 100 msec. At low speed: Developing Assembly Toner Sensor (TS2) signals were detected 4500 times in a row at intervals of 100 msec.
• Remedy: 1. Check the connection of the Connector (J209). 2. Correct the wiring. 3. Replace the Developing Assembly Toner Sensor (TS2).

• Code: E025-0000
• Description: Connector disconnection of the Hopper Toner Sensor (TS1) or the DC Controller PCB (J211)
  Hopper Toner Sensor (TS1) connection detection signals were not detected 10 times in a row in 100 msec. * If paper is being fed, the error occurs after the paper has been delivered.
• Remedy: 1. Check the connection of the Connector (J211). 2. Replace the Hopper Toner Sensor (TS1). 3. Replace the DC Controller PCB (PCB1).

• Code: E025-0001
• Description: Bottle Motor (M5) error
  The lock detection flag of the Bottle Motor (M5) was monitored at intervals of 2 msec, and the same level was detected 800 times in a row. * If paper is being fed, the error occurs after the paper has been delivered.
• Remedy: 1. Replace the Bottle Motor (M5). 2. Replace the DC Controller PCB (PCB1).

• Code: E110-0001
• Description: Laser Scanner Motor error
  After startup of the Laser Scanner Motor, the speed lock signal of the Laser Scanner Motor never showed lock status although a specified period of time had passed. *When the same status was detected again after executing an error retry.
• Remedy: 1. Check the Laser Scanner Unit connector. 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (PCB1).

• Code: E110-0002
• Description: Laser Scanner Motor error
  After the speed lock of the Laser Scanner Motor had been settled, the speed lock signals showed unlocked status 10 times in a row at intervals of 100 msec. *When the same status was detected again after executing an error retry.
• Remedy: 1. Check the Laser Scanner Unit connector. 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (PCB1).

• Code: E110-0003
• Description: Laser Scanner Motor error
  The speed lock signal of the Laser Scanner Motor never showed lock status although 6.5 seconds (when switching from low speed to normal speed) or 8 seconds (when switching from normal speed to low speed) have passed. *When the same status was detected again after executing an error retry.
• Remedy: 1. Check the Laser Scanner Unit connector. 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (PCB1).

• Code: E196-0000
• Description: EEPROM access error
  During communication with EEPROM, a communication error occurred, and the error was not cleared although a retry was executed three times. * If paper is being fed, the error occurs after the paper has been delivered.
• Remedy: 1. Replace the DC Controller PCB (PCB1).

• Code: E197-0000
• Description: Laser Driver PCB communication error
  Error in communication with the Laser Driver PCB (communication data failure)
• Remedy: 1. Check the Laser Scanner Unit connector. 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (PCB1).