Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR1750 — Trang 6/10

Code: E354-0002

Description: System error
Remedy: Contact the service company office

Code: E355-0000

Description: System error
Remedy: Contact the service company office

Code: E355-0004

Description: System error
Remedy: Contact the service company office

Code: E355-0005

Description: System error
Remedy: Contact the service company office

Code: E530-8001

Description: Front Alignment Motor (M4) error
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to move from the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 10 mm.
Remedy: 1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4). 2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4). 3. Replace the Front Alignment Plate HP Sensor (S4). 4. Replace the Front Alignment Motor (M4). 5. Replace the Finisher Controller PCB.

Code: E530-8002

Description: Front Alignment Motor (M4) error
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to be detected by the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 0.78 seconds.
Remedy: 1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4). 2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4). 3. Replace the Front Alignment Plate HP Sensor (S4). 4. Replace the Front Alignment Motor (M4). 5. Replace the Finisher Controller PCB.

Code: E531-8001

Description: Staple Motor (M9) error
The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).
Remedy: 1. Check the connector connection of the Staple Unit. 2. Check for open circuit of the Harness of the Staple Unit. 3. Replace the Staple Unit. 4. Replace the Finisher Controller PCB.

Code: E531-8002

Description: Staple Motor (M9) error
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Remedy: 1. Check the connector connection of the Staple Unit. 2. Disconnect the Harness of the Staple Unit. 3. Replace the Staple Unit. 4. Replace the Finisher Controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie