• Code: E575-0001
• Description: Gripper Unit Move Motor (M2) error
  The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds.
• Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E575-0002
• Description: Gripper Unit Move Motor (M2) error
  The gripper unit does not return to the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 0.1 seconds.
• Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E602-0001
• Description: The built-in SD card is not detected
• Remedy:

• Code: E602-1105
• Description: Access to the built-in SD card failed
• Remedy:

• Code: E711-0001
• Description: Error in UFDI communication
  The communication system error (such as reception timeout or checksum error) occurred.
• Remedy: 1.Check and Replace the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.

• Code: E713-0000
• Description: Erroneous communication with finisher
  The communication does not restart by the error retry after the communication failure with the finisher.
• Remedy: 1.Check the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.

• Code: E716-0000
• Description: Erroneous communication with optional cassette or 2-way unit
  After the presence of a cassette pedestal or a 2-way unit has been detected, the communication fails to be normal for 5 sec.
• Remedy: 1.Check the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Cassette Pedestal Driver PCB. 4.Replace the 2-way unit driver PCB.

• Code: E716-0010
• Description: Failure of the communication with the 2-way unit
  When the communication with the 2-way unit is faulty after detecting the connection with the finisher.
• Remedy: 1.Install the 2-way unit. 2.Check the cable. 3.Replace the DC Controller PCB (PCB4). 4.Replace the 2-way unit driver PCB.