• Code: E025-0001
• Description: Failure of the Bottle Motor (M6)
  The bottle motor (M6) is unlocked when it goes on for 12 consecutive times at 0.1 sec. intervals.
  * Error occurs after the delivery if a paper in passage exists.
• Remedy: 1.Replace the Bottle Motor (M6). 2.Replace the DC Controller PCB (PCB4).

• Code: E110-0001
• Description: Failure of the Scanner Motor (M21)
  The Scanner Motor (M21) speed lock signal does not indicate a locked state a specific period of time after the Scanner Motor (M21) has been started.
  * The same condition is detected after the error retry is performed.
• Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).

• Code: E110-0002
• Description: Failure of the Scanner Motor (M21)
  The speed lock signal indicates a deviation 10 times in sequence at intervals of 100 msec after the signal has indicated a locked state.
  * The same condition is detected after the error retry is performed.
• Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).

• Code: E110-0003
• Description: Failure of the Scanner Motor (M21)
  The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed.
  * The same condition is detected after the error retry is performed.
• Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).

• Code: E196-0000
• Description: Error in EEPROM access
  20 retries failed after error occurred during communication with EEPROM.
  * Error occurs after the delivery if a paper in passage exists.
• Remedy: 1.Replace the DC Controller PCB (PCB4).

• Code: E197-0000
• Description: Error in communication of Laser Driver PCB (PCB14)
  Communication error 1 with image PCB
• Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).

• Code: E197-0001
• Description: Error in communication of Laser Driver PCB (PCB14)
  Communication error 2 with image PCB
• Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).

• Code: E202-0000
• Description: There is an error in the detection of the CIS home position.
  1.The attempt to detect the home position fails when the CIS is moved forward.
  2.The attempt to detect the home position fails when the CIS is moved back.
• Remedy: 1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 64pin). 2.Replace the flexible cable. 3.Replace the CCD HP sensor (S22). 4.Replace the Scanner Motor (M21). 5.Replace the Relay PCB (PCB2). 6.Replace the Main Controller PCB (PCB1).