Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson EPLN1600 — Trang 6/7

Code: C1200

Description: EEPROM Write Error
Remedy: 1 EEPROM is defective. Initilialize EEPROM from the panel, then check operation. Replace the EEPROM. 2 C232 MAIN board is defective Replace the board

Code: C1210

Description: EEPROM Write Count Limit Error
Remedy: 1 EEPROM is defective. Initilialize EEPROM from the panel, then check operation. Replace the EEPROM. 2 C232 MAIN board is defective Replace the board

Code: C1400

Description: Printer Engine Initialization Failure
Remedy: 1 C232MAIN board is defective Replace the board

Code: C1999

Description: Other Hardware Error
Remedy:

Code: C2000

Description: Software Error
Remedy:

Code: E0003

Description: Fusing ASSY. Problem
Remedy: 1 Thermistor is defective. Does error occur immediately following power-on? • Guideline: Thermistor resistance should be between 200 and 350 KΩ when FUSER ASSY has been left at room temperature (18 to 20°C). Replace the thermistor. 2 Heater lamp is burned out. Confirm that heater lamp comes on when power is switched on with FUSER ASSY in cooleddown state. Replace the heater lamp. 3 Thermal fuse is severed. Check conductance through the thermal fuse at normal temperature Replace the fuse. 4 LVPS ASSY is defective. Confirm that voltage at pin 5 of connector CN210 (on the C232 MAIN board) is 0V at start of warm-up. Replace the LVPS ASSY.

Code: E0004

Description: ROS Assy. Problem
Remedy: 1 DRIVE ASSY not operating correctly. Remove the fuser unit and Imaging Cartridge, then rotate the DRIVE ASSY gear by hand. Confirm that the gear turns smoothly. Replace the DRIVE ASSY 2 DRIVE ASSY is defective. Check the resistance of the motor coil. The resistance should be 1 to 3W. Replace the DRIVE ASSY. 3 LVPS ASSY is defective. Confirm +24VDC with Imaging Cartridge removed and INTERLOCK SW=ON. Replace the LVPS ASSY.

Code: E0005

Description: Fan Motor Problem
Remedy: 1 Fan is defective. Confirm that fan comes on at power-on. Replace the fan. 2 LVPS ASSY is defective. Confirm that pin 1 of LVPS connector P/J102 is at +24V. Replace the LVPS ASSY.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie