• Code: 1227
• Description: PF Motor Step-out error
  PF Motor is out of step.
• Remedy: Clean the PF Scale. Replace the PF Motor. Check the connection of the PF Encoder. Check the installing position of the PF Encoder. Replace the PF Encoder.

• Code: 1228
• Description: PF servo parameter error
  The PF Motor is overloaded abnormally.
• Remedy: Check if there is any foreign material at the driven section of the PF Motor. Replace the PF Motor.

• Code: 131B
• Description: Head driver (transmission gate) overheat error
  The temperature of the Head Driver rises, and reaches the specified level.
• Remedy: Check the connection of the Head FFC, and if there is abnormality (slant connection or the like), correct it. Replace the Printhead.

• Code: 1400
• Description: Pressure failure error
  The Pressure Sensor does not react even the pressurizing continues for the specified period of time.
• Remedy: Check the connection of the Pressure Pump Unit. Check the connection of the Pressure Tubes. Replace the Pressure Pump Unit (Pressure Motor, Pressure Sensor).

• Code: 1410
• Description: Pump motor drive timeover error
  The motor driving does not end even after the specified period of time has passed.
• Remedy: Install the latest firmware. Replace the Main Board Assy.

• Code: 1430
• Description: Cartridge Holder Maintenance
  The life of the waste ink pad for the leakage of the Ink Cartridge replacement has reached its limit. (the life is controlled by counting the times of replacing the cartridges.)
• Remedy: Replace the Ink Cartridge Holder and clear the counter using the Adjustment Program.

• Code: 1434
• Description: Ink cover unlock error
  The Ink Cover cannot be opened.
• Remedy: If there is an obstacle in front of the cover, remove it. Check if the Ink Cover is installed properly. Check the solenoid that locks the Ink Cover and the sensor that detects the open/closed status of the Ink Cover.

• Code: 1435
• Description: Cap HP detection error
  The home position of the Cap Unit cannot be detected.
• Remedy: Check the connection of the Ink System Unit. Replace the Ink System Unit.