Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 7500 — Trang 3/4

Code: 0001000E

Description: Cover sensor malfunction (01)
Left sensor. One or both cover open sensors (interlock switch) located at either end of the cover shaft is malfunctioning.
Remedy: Make sure the sensor(s) are properly installed. If that does not solve the problem, check the cover open sensor connection. If there still is a problem, try the following. • Replace the malfunctioning cover sensor • Replace the Main Board

Code: 0001000F

Description: CR motor PWM output error
Remedy: • Check the cutter housing, slightly loosen screws if necessary • Replace the Main Board.

Code: 00010010

Description: PF motor PWM output error
Remedy: • Replace the Main Board

Code: 00020000

Description: NVRAM error
Remedy: • Write down the error code, turn the printer off and back on again to confirm whether the error recurs. If the same error recurs, replace the Main Board.

Code: 00020001

Description: Internal RAM check error
Remedy: • Write down the error code, turn the printer off and back on again to confirm whether the error recurs. If the same error recurs, replace the Main Board.

Code: 00020002

Description: SRAM check error
Remedy: • Write down the error code, turn the printer off and back on again to confirm whether the error recurs. If the same error recurs, replace the Main Board.

Code: 00020003

Description: DRAM check error
Remedy: Replace the SIMM installed in CN19 and confirm whether the error recurs.

Code: 0002000B

Description: Memory/Mail Box reception error
Data (also can be command code) reception error caused by outside factors such as power-drain during PC-side data transmission or printer reception. Also could be due to interference in interface cable or a warn cable, and so on.
Remedy: • Turn the printer off and back on again, and then resend the print job. If you cannot regenerate the error, have a nice day. • Make sure no machines that share the same power supply (with the PC or printer) are turned on while the print job is being sent. • Make sure the interface cable is within specifications for this printer. • Replace the interface cable; it may be worn out. • To make sure an errant command code is not the cause try sending a different print job, or send the print job from another application or another PC. • Write down the error code, turn the printer off and back on again to confirm whether the error recurs. If the same error recurs, replace the Main Board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie