• Code: 30.01.23
• Display: 30.01.23
• Description: A scanner calibration error has occurred.
• Remedy: 1. Print a calibration target from the Diagnostics menu and calibrate the scanner. 2. If the error continues, replace the scanner flatbed assembly.

• Code: 30.01.24
• Display: 30.01.24
• Description: The ADF jam-access door is open.
• Remedy: 1. Ensure the ADF jam-access door is closed. 2. If the error persists, ensure the sensor connector CN302 on the ADF intermediate PCB is firmly seated. 3. Ensure connectors CN301 on the ADF intermediate PCB and CN105 on the scan control board are firmly seated. 4. Replace the ADF assembly. 5. Replace the scan control board.

• Code: 30.01.25
• Display: 30.01.25
• Description: A general error has occurred in the scanner ADF. This error is most likely a memory corruption error.
• Remedy: 1. Reseat the 256 MB memory DIMM on the back side of the formatter. 2. Replace the 256 MB memory DIMM on the back side of the formatter. 3. Replace the formatter.

• Code: 30.01.29
• Display: 30.01.29
• Description: The ADF output bin is full.
• Remedy: 1. Remove all media from the ADF output bin. 2. If the message persists, ensure the sensor connector CN303 on the ADF intermediate PCB is firmly seated. 3. Ensure connectors CN301 on the ADF intermediate PCB and CN105 on the scan control board are firmly seated. 4. Replace the ADF assembly. 5. Replace the scan control board.

• Code: 30.01.36
• Display: 30.01.36
• Description: The scanning firmware upgrade failed. The MFP automatically tires to upgrade the firmware again the next time the MFP is power cycled.
• Remedy: 1. Turn the MFP off and then on to try to clear the message. 2. If the error persists, resend the firmware upgrade. 3. If the error continues, replace the scan control board.

• Code: 40
• Display: 40 BAD EIO X TRANSMISSION
• Description: The connection between the MFP and the EIO card in the specified slot has been broken.
• Remedy: 1. Touch OK to continue printing. 2. Power cycle the MFP. 3. Resend the print job. 4. If the error still occurs, replace the EIO card in slot X.

• Code: 40
• Display: 40 BAD SERIAL TRANSMISSION
• Description: A serial data error (parity, framing, or line overrun) occurred as data was being sent by the computer.
• Remedy: Touch OK to clear the error message. (Data will be lost.)

• Code: 40
• Display: 40 EMBEDDED I/O BAD TRANSMISSION
• Description: A connection with the embedded Jetdirect print server has been broken.
• Remedy: 1. Touch OK to continue printing. 2. Power cycle the MFP. 3. Resend the print job. 4. If the error still occurs, replace the formatter.