Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 1050C — Trang 4/6

Code: 0A0030

Description: Problem in Depressurizing Air System.
Remedy: • Check the APS for any signs of Ink. Also inspect ALL Ink Cartridges for any signs of leaking (the bottom valve of the Ink Cartridge will contain ink).• If there is Ink Leakage, replace ALL Ink Cartridges, the APS (

Code: 0A0040

Description: Ink Tubes Initialization Failure Due to Low Air Pressure.
Remedy: • Check all the cables of the APS and make sure they are correctly connected and are NOT damaged.• Check all the tubes of the APS and Tubes System and make sure they are correctly connected and are NOT pinched or damaged.• Replace ONE Ink Cartridge at a time, checking if the error code disappears.• Faulty APS Sensor or APS Pump. Replace the complete APS

Code: 0A0050

Description: The Printer has detected a leak in the Tubes System before the life of the System.
Remedy: • The leak detector could have been triggered due to condensation in the Printer. Power OFF the Printer and allow the Printer to dry for 15 minutes. Power ON the Printer and check if the error code has disappeared.• If the Error Code reappears, replace the complete Tubes System (SRK).

Code: 0A0060

Description: The Printer has detected a leak in the Tubes System after the life of the System.
Remedy: • The leak detector could have been triggered due to condensation in the Printer. Power OFF the Printer and allow the Printer to dry for 15 minutes. Power ON the Printer and check if the error code has disappeared.• If the error code reappears, replace the complete Tubes System (SRK).

Code: 0A0070

Description: The Backup EEROM contents stored in the Tubes System are not consistent with the ones required by the firmware.
Remedy: • Perform the Calibrations Backup.

Code: 0B0000

Description: Bad Ambient Temperature measured.
Remedy: • Make sure that the Ambient temperature is within the allowed range (between 0 and 55 Degrees Centigrade).• Replace the Electronics Module.

Code: 0B0001

Description: Bad Humidity read.
Remedy: Replace the Electronics Module

Code: 0B0002

Description: Bad IDS pressure read.
Remedy: • Check that the cable from the Ink Supply Station (ISS) PCA to the Ink Supply Station is correctly connected.• Check that the Air Pressurization System Sensor Cable is correctly connected and is NOT damaged.• Check all the tubes of the APS and make sure they are NOT pinched or damaged.• Faulty APS Sensor. Replace the complete APS.• If the error code continues, replace the Electronics Module
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie