• Code: 06030A
• Description: Error in finding the Mark Encoder.
• Remedy: • Clean the Mark Encoder if necessary (use the Overdrive Cleaning Utility to position the Mark Encoder).• Clean the Line Sensor (located on the Carriage Assembly).• Perform the Line Sensor Calibration.• Perform the Mark Encoder Calibration.• Replace the Trailing Cable.• Replace the Carriage Assembly.• If the Error Code continues, replace the Electronics Module

• Code: 06030B
• Description: The Ambient Temperature measured is out of the normal range.
• Remedy: • Make sure that the Ambient temperature is within the allowed range (between 0 and 55 Degrees Centigrade).• Replace the Electronics Module.

• Code: 070100
• Description: Firmware Error.
• Remedy: • Model and Serial Number of the printer.• Which firmware revision the printer is using (See Note below). Check firmware in Utilities / Statistics / Code rev.• The complete error number (See Note below).• The Service Configuration Print.• The Current configuration sheet.• Which software application the customer is using (name, version, etc.).

• Code: 080001
• Description: PostScript Error.
• Remedy: Power the Printer OFF and ON again to see if the System Error disappears. If the Error Code reappears, then report the error to the HP response Center or the nearest HP Support Office, stating the following information.

• Code: 09xxxx
• Description: EIO Accessories (EIO Card/Hard Disk Drive) Error.
• Remedy: • Switch the Printer OFF and ON again and wait for the initialization.• If the Error code continues to appear, switch the Printer OFF. Remove the EIO Card (if installed) and make sure that the Hard Disk Drive is installed correctly by pushing it firmly inwards and checking that the two installation screws are completely tightened. Switch the Printer ON again. If the error codes 09Axxx or 09Bxxx appear then replace the Hard Disk Drive.• If the Error Code disappeared after removing the EIO Card, then switch the Printer OFF and reinstall the EIO Card, making sure that the two installation screws are completely tightened. Switch the Printer ON again. If the Error Code reappears, then the EIO Card could be faulty. Replace the EIO Card.• If Error Code 09Cxxx appears after initialization, then replace the Electronics Module.• Once the Error Code has been solved, print an Internal Demo Print to make sure that the Hard Disk Drive is functioning correctly. If the Error Code reappears, then use the above information to troubleshoot the problem.

• Code: 0A0000
• Description: The Air Pressure is below the minimum requirement.
• Remedy: n Check all the cables of the APS and make sure they are correctly connected and are NOT damaged. n Check all the tubes of the APS and Tubes System and make sure they are correctly connected and are NOT pinched or damaged. n Check that the Air Tube from the APS is correctly connected to the Tubes System. n Faulty APS Sensor, APS Valve or APS Pump. Replace the complete APS. n Replace ONE Ink Cartridge at a time, checking if the error code disappears.

• Code: 0A0010
• Description: Problem in Pressurizing the Air System.
• Remedy: • Replace ONE Ink Cartridge at a time, checking if the error code disappears.• Check all the cables of the APS and make sure they are correctly connected and are NOT damaged.• Check all the tubes of the APS and Tubes System and make sure they are correctly connected and are NOT pinched or damaged.• Faulty APS Sensor, APS Valve or APS Pump. Replace the complete APS.

• Code: 0A0020
• Description: Error in Calibrating the APS Sensor.
• Remedy: • Check all the cables of the APS and make sure they are correctly connected and are NOT damaged.• Check all the tubes of the APS and Tubes System and make sure they are correctly connected and are NOT pinched or damaged.• Faulty APS Sensor or APS Valve. Replace the complete APS