• Code: 14.47:10
• Description: Pinch Power regulator OverTemp
• Causes: Pinch Power regulator OverTemp.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check cable connections. 4. Check that the input voltage is within specifications. 5. Replace the sine-wave converter.

• Code: 14.48:10
• Description: Pinch Power regulator overvoltage or short-circuit
• Causes: Pinch Power regulator overvoltage or short-circuit.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check cable connections. 4. Check that the input voltage is within specifications. 5. Replace the sine-wave converter.

• Code: 14.49:10
• Description: Pinch sine-wave converter failure
• Causes: Pinch sine-wave converter failure.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the sine-wave converter.

• Code: 14.51:10
• Description: Overdrive power regulator V null and no fault
• Causes: Overdrive power regulator V null and no fault.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Replace the control cables to the sine-wave converter.

• Code: 14.52:01
• Description: Overdrive power regulator V null and fault
• Causes: Overdrive power regulator V null and fault.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check the Residual Current Circuit Breakers. 4. Check the input voltage.

• Code: 14.53:01
• Description: Overdrive power regulator V lower than 140
• Causes: Overdrive power regulator V lower than 140.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

• Code: 14.54:01
• Description: Overdrive power regulator V lower than 180
• Causes: Overdrive power regulator V lower than 180.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

• Code: 14.55:01
• Description: Overdrive power regulator V higher than Vmax
• Causes: Overdrive power regulator V higher than Vmax.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.