Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet L65500 — Trang 7/24

Code: 14.71:10

Description: Curing power regulator V null and no fault
Causes: Curing power regulator V null and no fault.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Replace the control cables to the sine-wave converter.

Code: 14.72:01

Description: Curing power regulator V null and fault
Causes: Curing power regulator V null and fault.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check the Resident Current Circuit Breakers. 4. Check the input voltage.

Code: 14.73:01

Description: Curing power regulator V lower than 140
Causes: Curing power regulator V lower than 140.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

Code: 14.74:01

Description: Curing power regulator V lower than 180
Causes: Curing power regulator V lower than 180.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

Code: 14.75:01

Description: Curing power regulator V higher than Vmax
Causes: Curing power regulator V higher than Vmax.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

Code: 14.76:11

Description: Curing power regulator V could not be read
Causes: Curing power regulator V could not be read.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check cable connections. 3. Replace the control cables to the sine-wave converter.

Code: 14.80:10

Description: Curing power regulator current not null
Causes: Curing power regulator current not null.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the sine-wave converter. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.

Code: 14.81:10

Description: Curing power regulator current too high
Causes: Curing power regulator current too high.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check heaters with tester and replace heaters if necessary (short-circuit). 4. Replace the sine-wave converter.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie