Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet Z6800 Photo Production Printer — Trang 13/17

Code: 58.1:10

Description: Embedded PhotoSpectrometer (ESP) Shutter Actuator failure
Remedy: • Replace the ESP Shutter Actuator Assembly. • Perform the ESP Shutter Diagnostic Test to ensure that there is no other problem preventing shutter operation. • Perform am ESP basic test (CLC) to ensure that the replaced part is working correctly.

Code: 58.2:10

Description: Embedded PhotoSpectrometer (ESP) Shutter Deactivator failure
Remedy: • Check that the Shutter Deactivator is correctly screwed into place. • Replace the Left Spittoon Assembly (which contains the Shutter Deactivator). • Perform the ESP Shutter Diagnostic Test to ensure that there is no other problem preventing shutter operation. • Perform a ESP basic test (CLC) to ensure that the replaced part is working correctly.

Code: 58:01

Description: Embedded PhotoSpectrometer (ESP) shutter error
Remedy: Execute the ESP Shutter Diagnostic Test.

Code: 58:10

Description: Embedded PhotoSpectrometer (ESP) failure
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord and turn on the printer. • Check that the ESP is installed in the Carriage. • Check that the ESP is correctly installed and screwed into place. • Check that the ESP cable is not damaged. • Check that the ESP cable is correctly connected to the Carriage PCA. • If the system error persists, replace the ESP Embedded SpectroPhotometer (ESP). • Perform an ESP basic test (CLC), to ensure that the replaced part is working correctly.

Code: 59.1:09

Description: Two electrical parts have been replaced at the same time
Remedy: Replace one part at a time, and restart the printer before replacing another.

Code: 59.2:00

Description: An unsupported or reused part has been installed
Remedy: Install only new parts recommended by HP for this printer.

Code: 60.1:11

Description: Initialization error
Remedy: • Turn the power off at the rear of the printer and disconnect the power cord. • Check that the printer is properly connected in all other respects. In particular, check that the tag cable is well connected to the ISS Top PCA, and the ISS Top PCA is well connected to the PrintMech PCA. • Reconnect the power cord and turn on the printer. • If the error persists, contact HP.

Code: 60.2:17

Description: Initialization error
Remedy: Contact HP.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie