Code :

Code: 30.1.3
Display: 30.1.3
Description: Document feeder pick error The ADF could not pick up the document. NOTE Appears as 30.01.03 on the event log.
Remedy: 1. Clear the jam. 2. If the ADF continues to jam, make sure that the document meets media specifications for the ADF. 3. Open the ADF cover and inspect the paper path for damage or obstructions. 4. Check the pickup rollers and separation pad for excessive wear or contamination. Replace if necessary.

Code: 30.1.34
Display: 30.1.34
Description: Cable error or loss of communication with the formatter.
Remedy: 1. Turn the device off and then turn the device on. 2. Make sure that the ribbon cable between the scanner control board and the formatter is not damaged and is correctly seated. 3. Make sure that the hard disk drive on the formatter is connected correctly and that the hard disk is functioning correctly. 4. If the message persists, replace the scanner control board or replace the formatter.

Code: 30.1.36
Display: 30.1.36
Description: Scanner firmware upgrade failed.
Remedy: The device will automatically try to upgrade the firmware again the next time the device is turned on. Turn the MFP power off, and then on. Resend the RFU.

Code: 30.1.7
Display: 30.1.7
Description: Communication error.
Remedy: 1. Turn the device off and then turn the device on. 2. Make sure that the ribbon cable between the scanner control board and the formatter is not damaged and is correctly seated.

Code: 30.1.8
Display: 30.1.8
Description: Scanner optical unit position error.
Remedy: 1. Check the scanner lock to verify that it is in the unlocked position. 2. Turn the device off and then turn the device on. 3. Make sure that the optical unit moves freely and that it is attached to the belt. 4. Check the scanner motor connector at the scanner control board (connector 10). 5. If the message persists, replace the scanner.

Code: 40
Display: 40 EIO <X> bad transmission To continue touch OK
Description: The connection between the device and the EIO card in the specified slot has been broken.
Remedy: Touch OK to clear the error message and continue printing. If the error persists, turn the power off and reseat the EIO device. Make sure that the network connections and configurations are correct.

Code: 40
Display: 40 Embedded I/O bad transmission To continue touch OK
Description: A temporary printing error has occurred.
Remedy: Turn the device off, and then turn the device on. Also, make sure that the network connections and configurations are correct. If the error persists, the embedded HP Jetdirect print server might be damaged. Replace the formatter.

Code: 41.1
Display: 41.X Error To continue touch OK
Description: A temporary printing error occurred.
unknown misprint error
Remedy: 1. Touch OK to clear the error. If the error is not cleared, turn the device off, and then turn the device on. 2. For a 41.2 error, check the laser/ scanner wire harness connectors from the scanner to the dc controller. If the error persists, replace the laser/ scanner. For a 41.8 error, check the fuser wire harness connectors. If the error persists, replace the fuser. Replace the dc controller PCA.