Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Konica-Minolta bizhub 600 — Trang 14/20

Code: C-6101

Description: The scanner home sensor (PS61) does not turn ON within a specified period of time after the scanner motor (M11) turns ON.
Causes: Scanner motor (M11) Scanner home sensor (PS61) Scanner drive board (SDB) Printer control board (PRCB)

Code: C-6301

Description: The EM signal shows an abnormal condition when a specified period of time elapses after the scanner cooling fan (FM9) turns ON. This abnormal condition recurs when a specified period of time elapses after FM9 is turned OFF and then ON again.
Causes: Scanner cooling fan (FM9) Scanner drive board (SDB) Printer control board (PRCB)

Code: C-6701

Description: Filter coefficient abnormality.
Causes: Overall control board (OACB) Image controller firmware

Code: C-6703

Description: After negation of SVV, the compression of images that are read in and their development into the page memory are not terminated within a specified period of time.
Causes: Overall control board (OACB)

Code: C-6704

Description: While in the image read, the compression processing from the scanner into the memory does not terminate within a specified period of time. The development from the scanner into the page memory does not terminate within a specified period of time.
Causes: Printer control board (PRCB) Overall control board (OACB)

Code: C-6706

Description: While in the image read, SVV does not turn OFF within a specified period of time and the preparation for scanning the next page cannot be started.
Causes: Overall control board (OACB)

Code: C-6707

Description: Shading correction abnormality (GA abnormality).
Causes: Overall control board (OACB) Image controller firmware

Code: C-6708

Description: AGC adjustment level abnormality. • The light blocking cover at the read section and the lens cover are removed. • The connector of the CCD board (CCDB) is disconnected. • The power cable of the CCDB is unplugged. • The IC protector of the CCDB converter board is cut off. • The light volume of the exposure lamp is excessive. • The exposure lamp does not light up.
Causes: CCD board (CCDB) Exposure lamp (L1)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie