Mã lỗi Konica-Minolta bizhub 600 — Trang 17/20
Description: When the main power switch (SW2) is ON, a region into which no write was made by the ISW is detected in the printer control firmware.
Causes: Printer controller firmware
Description: When ISW transfers data, the correct header information is not received in a specified period of time.
Causes: Printer cable Parallel port on PC
Description: When ISW transfers data, a checksum error or a header error is detected.
Causes: Printer cable firmware file corruption
Description: When ISW transfers data, the data is not written into the flash ROM correctly.
Causes: Printer cable The board to which the data is transferred.
Description: When the main power switch (SW2) is ON, a region into which no write was made by ISW is detected in the FS firmware.
Causes: FS firmware
Description: After ISW, the firmware of the main body does not match that of the printer.
Causes: Main body firmware Printer firmware
Description: Hard disk initialization abnormality. The hard disk is defective, or the connector is poorly connected.
Causes: Overall control board (OACB) Image controller firmware Hard disk /1 (HD-510)
Description: The JOB information cannot be stored on the hard disk.
Causes: Overall control board (OACB) Image controller firmware Hard disk /1 (HD-510)