Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Konica-Minolta bizhub C227 — Trang 8/31

Code: 75-43

Description: <When FS-534 or FS-534SD is installed> The RU entrance sensor (PS2) is not turned OFF (unlocked) even after the set period of time has elapsed after it is turned ON (blocked).
Causes: • RU entrance sensor (PS2) • FS control board (FSCB)
Remedy:

Code: 92-01

Description: The registration sensor (PS1) is not turned ON (unblocked) even after the lapse of a given period of time after a duplex paper feed sequence has been started.
Causes: • ADU transport motor (M5) • Registration sensor (PS1) • MFP board (MFPB)
Remedy:

Code: 92-02

Description: For the second-side feed of paper in the duplex mode, loop forming has not been complete before the second side of a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop.
Causes: • ADU transport motor (M5) • Registration sensor (PS1) • MFP board (MFPB)
Remedy:

Code: 92-40

Description: For the second-side feed of paper in the duplex mode, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output.
Causes: • ADU transport motor (M5) • Registration sensor (PS1) • MFP board (MFPB)
Remedy:

Code: 99-01

Description: • As a result of a paper size error, the controller transmits a forced stop command to the printer engine and the printer engine is internally processing the size error. • As a result of a paper size error, the controller transmits a forced stop command to the printer engine; but the paper causing the size error cannot be fed out.
Causes:
Remedy: Initial check items Open and close the front door of the main body.

Code: 99-02

Description: The controller transmits a forced stop command under a condition other than a paper size error during a print cycle.
Causes:
Remedy: Initial check items Open and close the front door of the main body.

Code: 99-03

Description: Image stabilization not completing a job.
Causes:
Remedy: Initial check items Open and close the front door of the main body.

Code: 99-04

Description: The finisher pre-drive is not completed even with a print start command received.
Causes:
Remedy: Initial check items Open and close the front door of the main body. Or, open and close the front door of the finisher.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie