• Code: D096
• Description: Hard disk access fault When the power switch ON, the hard disk fails to be access.
• Causes: HDD
• Remedy: 1 Replace the hard disk. 2 Format the hard disk.

• Code: D0A2
• Description: No SSD board (found during a disk check) The SSD board is not mounted.
• Causes: SSD board (SSDB)
• Remedy: 1 Install the SSDB. 2 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD.

• Code: D0A3
• Description: Wrong SSD board (found during a disk check) • A SSD board intended for another model is mounted. • The SSD board capacity is short.
• Causes: SSD board (SSDB)
• Remedy: 1 Replace SSDB. 2 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD.

• Code: D0A4
• Description: SSD board check disk error When the power switch ON, the SSD board fails to be checked.
• Causes: SSD board (SSDB)
• Remedy: 1 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD. 2 Replace SSDB. 3 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD.

• Code: D0A5
• Description: SSD board recovered (requiring reboot) When the power switch ON, the SSD board fails to be recovered.
• Causes: SSD board (SSDB)
• Remedy: 1 Turn OFF/ON the power switch. 2 Replace SSDB. 3 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD.

• Code: D0A6
• Description: SSD board access fault When the power switch ON, the SSD board fails to be access.
• Causes: SSD board (SSDB)
• Remedy: 1 Replace SSDB. 2 Using [Admin Settings] -> [Security Settings] -> [SSD Settings] -> [SSD Format], format the SSD.

• Code: D3A2
• Description: Counter error A write error occurs in the counter area.
• Causes: MFP board (MFPB)
• Remedy: 1 Check the MFPB for its mounting condition and correct any faulty condition. 2 Replace MFPB 3 If the same trouble code persists after the abovementioned procedures, the EEPROM is probably damaged.

• Code: D3F1
• Description: Successful completion of counter backup The counter backup process is completed successfully.
• Causes:
• Remedy: 1 This code is displayed when the counter backup process is completed successfully. When this code is displayed, turn OFF/ON the power switch and then perform the given steps. G.3.10 MFP board (MFPB)