Remedy: • Check to see if the toner cartridge is a supported cartridge. Note: Once the cartridge shipped with the printer is exhausted, it must be replaced by a supply cartridge (refer to the User’s Guide for part numbers.) If the specified toner cartridge is a supported cartridge, reseat the cartridge. • Inspect the toner cartridge contacts for damage or contamination. Replace the toner cartridge if defective. • Inspect JSBTN1 cable connection. Properly connect the cable if not connected properly. Replace the cable if damaged. • If the problem still exists, replace the system board.
Remedy: Select Continue to clear the message and continue printing. Note: The printer does not automatically reprint the page that prompted the message. • Check the tray length and width guides to ensure the media is properly fitted. • Make sure the print job is requesting the correct size of media. • Adjust the Paper Size setting for the media size being used. • If the MP Feeder Size is set to Universal, make sure the media is large enough for the formatted data. • Cancel the current job. Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. • If the problem still exists, replace the system board.
Description: Insufficient memory to support Resource Save feature
Remedy: • Select Continue to disable Resource Save and continue printing. • To enable Resource Save after receiving this message: - Make sure the link buffers are set to Auto, then exit the menus to activate the link buffer changes. - When Ready is displayed, enable Resource Save. • Install additional memory. • If this does not fix the problem, replace the system board.
Remedy: • Select Continue to print the portion of the job already stored and begin collating the rest of the job. • Cancel the current job. • If this does not fix the problem, replace the system board.
Description: Insufficient memory for Flash Memory Defragment operation
Remedy: • Select Continue to stop the defragment operation and continue printing. • Delete fonts, macros, and other data in printer memory. • Install additional printer memory. • If this does not fix the problem, replace the system
Description: Insufficient memory, Some Held Jobs Were Not Restored
Remedy: • The printer deleted some held jobs in order to process current jobs. • Select Continue to clear the message. • If this does not fix the problem, replace the system board
Description: Insufficient memory, Some Held Jobs Will Not Be Restored
Remedy: • The printer was unable to restore some or all of the confidential or held jobs on the hard disk. • Select Continue to clear the message. • If this message occurs again, replace the hard drive. • If this does not fix the problem, replace the system boar
Remedy: There is insufficient memory to perform the Flash Memory Defragment operation. The user can: • Delete font, macros, and other data in memory. • Install additional printer memory.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.