Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark S800 — Trang 4/6

Code: 1207

Description: Paper System Error A paper system error control failure was detected.
Remedy: Clear the paper path. Unplug the All-In- One from the wall outlet; wait a few seconds, then plug the All-In-One back in and turn the power on. If the remains, then replace the All-In-One. Service: Replace the system board.

Code: 1208

Description: Printhead Memory Error Firmware is unable to read the printhead’s memory.
Remedy: Clean the contacts. If the problem persists, then replace the printhead. If the problem remains, then replace the All-In- One. Service: Replace the printhead. If the problem remains, then replace the system board.

Code: 1209

Description: FLASH Programming Error Could not program FLASH.
Remedy: The printer will auto reset. If the problem remains, then replace the All-In-One. Service: Replace the printhead.

Code: 120A

Description: Undefined Error The microprocessor has encountered an abort or undefined instruction.
Remedy: Unplug the All-In-One from the wall outlet; wait a few seconds, then plug the All-In- One back in, and turn the power on. If the problem remains, then replace the All-In- One. Service: Replace the system board.

Code: 120B

Description: Address Error Firmware attempted to access invalid address space.
Remedy: Unplug the All-In-One from the wall outlet; wait a few seconds, then plug the All-In- One back in, and turn the power on. Service: Replace the system board.

Code: 120C

Description: NVRAM Error An error was detected in reading or writing NVRAM.
Remedy: Unplug the All-In-One from the wall outlet; wait a few seconds, then plug the All-In- One back in, and turn the power on. If the problem remains, then replace the All-In- One. Service: Replace the system board.

Code: 120D

Description: Never Error Stack over and under flow error; Code error.
Remedy: Unplug the All-In-One from the wall outlet; wait a few seconds, then plug the All-In- One back in, and turn the power on. If the problem remains, then replace the All-In- One. Service: Replace the system board.

Code: 120E

Description: Software Detected Error An error condition was detected in the software control code.
Remedy: Unplug the All-In-One from the wall outlet; wait a few seconds, then plug the All-In- One back in, and turn the power on. If the problem remains, then replace the All-In- One. Service: Reinstall the print driver. If the problem remains, then replace the system board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie