Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark X854e — Trang 22/23

Code: 986.00

Description: Service finisher error Sensor (eject clamp HP) on failure
Remedy: The sensor (eject clamp HP) is not turned on within 500 ms after the eject clamp up starts.

Code: 986.01

Description: Service finisher error Sensor (eject clamp HP) off failure
Remedy: The sensor (eject clamp HP) is not turned off within 200 ms after the eject clamp down starts.

Code: 987.00

Description: Service finisher error Sensor (media eject shaft HP) on failure
Remedy: The sensor (media eject shaft HP) is not turned on within 200 ms after the set clamp starts operating.

Code: 987.01

Description: Service finisher error Sensor (media eject shaft HP) off failure
Remedy: The sensor (media eject shaft HP) is not turned off within the specified time after the set clamp ends operating.

Code: 988.00

Description: Service finisher error Sensor (punch unit side reg 1) on failure Sensor (punch unit side reg 2) on failure
Remedy: The sensor (punch unit side reg 1) or sensor (punch unit side reg 2) did not detect the media correctly or is defective.

Code: 988.01

Description: Service finisher error Sensor (punch unit side reg 1) off failure Sensor (punch unit side reg 2) off failure
Remedy: The sensor (punch unit side reg 1) or sensor (punch unit side reg 2) did not detect the media correctly or is defective.

Code: 989.00

Description: Service finisher error Stapler unit failure
Remedy: The off/on status of the sensor (stapler unit motor HP) is not detected within the specified time after the stapler unit motor (forward operation). Or the sensor (stapler unit motor HP) is not turned on within the specified timer after the stapler unit motor is on (reverse operation).

Code: 990.00

Description: Service finisher error Sensor (stapler carriage HP) on failure
Remedy: The sensor (stapler carriage HP) is not turned on within two seconds after the stapler starts moving toward the staple position, and also the sensor (stapler carriage HP) is turned off. Or the sensor (stapler carriage HP) is not turned on after the stapler was moved to the staple position. Or the sensor (stapler carriage HP) is turned off again after the sensor (stapler carriage HP) is turned on, and the stapler stopped its moving.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie