Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C710n

Code: -

Display: SDRAM ERROR
Description: CU board (CU) DCON access error
Remedy: Does this error recur? Yes Turn on the power again. Replace the CU board.

Code: -

Display: CRC CHECK NG ( )
Description: CRC check error of the PU downloaded data
The CRC check error is detected upon completion of the PU data downloading (PU firmware, Custom media data)
Remedy: After turning on the power again, perform downloading again. (This error does not occur during the normal operation because this processing is not carried out.)

Code: -

Display: LOADER VERSION
Description: PU board Flash ROM hash check error
Remedy: Does this error recur? Yes Turn on the power again. Replace the PU board.

Code: -

Display: WDT ERROR R14=XXXX
Description: PU firmware runaway
Remedy: Does this error recur? Yes Turn on the power again. Replace the PU board.

Code: -

Display: COMMUNICATION ERROR
Description: I/F error between PU and CU
Remedy: Is the CU assembly installed normally? Does this error recur?
Re-install the CU assembly normally. Replace the CU board. Replace the PU board.

Code: -

Display: ASIC ERROR
Description: DCON access error
Remedy: Does this error recur? Yes Replace the CU board.

Code: 002 ... 005

Display: Restart the printer. 002: Error~ 005: Error
Description: CPU Exception
Remedy: Does the error display recur? If the RAM DIMM is installed, remove it and turn off the power of the printer and back on. Replace the CU board. Re-install the RAM DIMM. Replace the RAM DIMM.

Code: 020

Display: Service call 020: Error
Description: CU ROM Hash Check Error
Remedy: Does the error display recur? Yes Turn off the power of the printer and back on. Replace the CU board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie