Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C710n — Trang 6/7

Code: 176, 177

Display: Service call 176: error 177: error
Description: The backup roller thermistor has detected an abnormal temperature (high temperature or low temperature.)
Remedy: Does this error recur? Turn on the power again. Replace the fuser unit. Replace the low voltage power supply unit.

Code: 181, 182

Display: Service call 181: error 182: error
Description: Option unit I/F error (181=Duplex Unit, 182=Option Tray)
Remedy: Does this error recur? Turn on the power again. Check for sure connection of the connectors. Replace the option unit.

Code: 190

Display: Re-start the printer. 190: error
Description: System memory overflow
Remedy: Does this error recur? Yes Turn on the power again. Increase the addon RAM DIMM.

Code: 200, 201, 202

Display: Service call 200: error~ 202: error
Description: PU Firmware Download Error
Error has occurred during rewriting of the PU firmware.
Remedy: After turning on the power again, perform downloading again. (This error does not occur during the normal operation because this processing is not carried out.)

Code: 203, 204, 207, 208

Display: Re-start the printer. 203: error
204: error 207: error 208: error
214: error FOC: error FFF: error
Description: CU program error (The error numbers 203 through 214 do not occur under the normal operation.)
Illegal processing is executed by the CU program.
Remedy: After turning off the power, check for the normal connection between the CU board and the PU board. Then, turn on the power again.

Code: 209

Display: Re-start the printer. 209: Download error
Description: Custom Media Type table downloading has failed
Remedy: After turning on the power again, perform downloading again. (This error does not occur during the normal operation because this processing is not carried out.)

Code: 214, F0C, FFF

Display: Re-start the printer. 203: error
204: error 207: error 208: error
214: error FOC: error FFF: error
Description: CU program error (The error numbers 203 through 214 do not occur under the normal operation.)
Illegal processing is executed by the CU program.
Remedy: After turning off the power, check for the normal connection between the CU board and the PU board. Then, turn on the power again.

Code: 230

Display: Service call 230: error
Description: RFID Reader not Installed
Remedy: RFID read device error Does this error recur?
Check for normal connection of the RFID R/W board. Replace the RFID R/W. Replace the P6 X board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie