Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C9300 — Trang 8/12

Code: 203 ... 208

Display: Service Call 203: Error ~ 208: Error 210: Error ~ 214: Error 0xFFE: Error 0xFFF: Error
Description: An error was detected of the CU program.
Remedy: Reinstall the CU board. Is the error message displayed again? Please report the address (24 charactoers) in the indicated LCD (if possible). Turn the printer OFF/ON.

Code: 209

Display: POWER OFF/ON 209: DOWNLOAD ERROR
Description: Downloading Media Table to PU has failure. ( Related to Custum Media Type )
Turn the printer OFF/ON, and retry to download the PU firmware, again.
Remedy: Turn the printer OFF/ON, and retry to download the PU firmware, again. Usually, the procedure ( PU firmware download ) which isn’t done.

Code: 210 ... 214

Display: Service Call 203: Error ~ 208: Error 210: Error ~ 214: Error 0xFFE: Error 0xFFF: Error
Description: An error was detected of the CU program.
Remedy: Reinstall the CU board. Is the error message displayed again? Please report the address (24 charactoers) in the indicated LCD (if possible). Turn the printer OFF/ON.

Code: 310

Display: Close cover 310: Top cover open
Description: Printer engine cover open.
Remedy: 1) Check if top cover is open. 2) Check if cover switch is proper.
Close top cover. Close side cover. Replace cover switch.

Code: 320

Display: Reset fuser 320: Fuser error
Description: Same unit not detected upon power ON or opening cover.
Remedy: 1) Is error message displayed? 2) Is fuser unit set properly? 3) Does error reoccur?
Check if fuser is set properly. Reset fuser and turn ON power again. Replace fuser unit assembly.

Code: 321

Display: Turn power OFF and wait 321: MOTOR OVERHEAT
Description: Printer cannot be used temporarily due to motor overheat.
Remedy: Turn ON power after a while.

Code: 323

Display: Open/close cover 323: Paper thickness error
Description: Sensor output out of range with no media. (Only for Factory Mode)
Remedy: 1) Are foreign objects mixed in sensor? 2) Does printer recover when detecting paper thickness by opening/closing tray? 3) Does printer recover by power OFF/ON.
Remove foreign objects. Normal.

Code: 324

Display: Open/close cover 324: Paper thickness error
Description: Sensor output gap out of range with no media. (Only for Factory Mode)
Remedy: 1) Are foreign objects mixed in sensor? 2) Does printer recover when detecting paper thickness by opening/closing tray? 3) Does printer recover by power OFF/ON.
Remove foreign objects. Normal.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie