Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C9500 — Trang 7/12

Code: 160 ... 163

Display: Service Call 160: Y Toner 161: M Toner 162: C Toner 163: K Toner
Description: Error detected by toner sensor.
Remedy: 1) Is error message displayed? 2) Does error reoccur?
Replace toner sensor or assembly (Y71-PWB). Same as above.

Code: 170 ... 175

Display: Service Call 170: Error 171: Error 174: Error 175: Error
Description: Short circuit in fuser thermistor or open detected (high temp. or low temp.)
Remedy: 1) Is error message displayed? 2) Does error reoccur?
Turn ON power again. Replace thermistor and turn power OFF. Leave aside for 30 min.

Code: 172 ... 176

Display: Service Call 172: Error 176: Error
Description: Thermistor indicates high-temperature error.
Remedy: 1) Is error message displayed? 2) Does error reoccur?
Turn ON power again. Replace thermistor and turn power OFF. Leave aside for 30 min.

Code: 173, 177

Display: Service Call 173: Error 177: Error
Description: Thermistor indicates low-temperature error.
Remedy: 1) Is error message displayed? 2) Does error reoccur?
Turn ON power again. Replace thermistor and turn power OFF. Leave aside for 30 min.

Code: 179

Display: Service Call 179: Error
Description: Wrong fuser standard.
Remedy: 1) Does fuser match with model and power voltage? 2) Error reoccurs after setting fuser properly.
Set proper fuser. Check if fuser is set properly. Replace fuser.

Code: 180 ... 186

Display: Service Call 180: Error ~ 186: Error
Description: Communication disability with option unit detected by engine. 180: Envelope Feeder ( Not used ) 181: Duplex unit 182: Tray2 unit 183: Tray3 unit 184: Tray4 unit 185: Tray5 unit 186: Finisher unit
Remedy: Is the error message displayed sgin? Check the connector between the printer and the unit, and reinstall the unit.

Code: 187

Display: Service Call 187: Error
Description: Communication with control panel disabled
Remedy: Is cable properly connected to control panel? Connect properly. Replace control panel and cable.

Code: 200 ... 202

Display: Service Call 200: Error ~ 202: Error
Description: Error occurered while writing over the PU firmware. ( This does not occur at user level. )
Turn the printer OFF/ON, and retry to download the PU firmware, again.
Remedy: Turn the printer OFF/ON, and retry to download the PU firmware, again. Usually, the procedure ( PU firmware download ) which isn’t done.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie