Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI proColor 810 — Trang 4/9

Code: 111

Display: Contact the Service center. 111: Error
Description: Duplex unit for other model is detected.
Remedy: Is the duplex unit for that specific model installed? No Install the correct duplex unit.

Code: 112, 113

Display: Contact the Service center. 112: Error 113: Error
Description: Optional tray for other model is detected.
Remedy: Is the optional tray for that specific Model installed? No Install the correct optional tray.

Code: 121

Display: Contact the Service center. 121: Error
Description: High voltage power supply interface error
Remedy: Is the cable connecting the PU board to the high voltage unit connected normally? Have you checked defective contact of contactor points?
Re-connect them normally. Check for defective contact of the high voltage system. Replace the high voltage power supply.

Code: 122

Display: Contact the Service center. 122: Error
Description: Low voltage power supply fan error
Remedy: Is the fan (bottom right of the front) of the low voltage power supply block working? Is the fan connector connected correctly?
Check for sure connection of the fan connector. Replace the PU board. Replace the fan motor. Replace the PU board.

Code: 123

Display: Contact the Service center. 123: Error
Description: Environment humidity is abnormal./ Humidity sensor is not connected.
Remedy: Does this error recur? Yes Turn off the power of the printer and back on. Replace the control panel board.

Code: 124

Display: Contact the Service center. 124: Error
Description: Environment temperature is abnormal.
Remedy: Does this error recur? Yes Turn off the power of the printer and back on. Replace the control panel board.

Code: 126

Display: Shut off the electric power and wait for a while. 126: The printer is condensing.
Description: Dew condensation of the printer is detected.
Remedy: This error can easily occur when a printer is brought in to indoor from outdoor. Leave the printer for 2 hours or half day under room temperature, and turn on the power again. After leaving a printer under room temperature, turn on the power again.

Code: 127

Display: Contact the Service center. 127: Error
Description: Fuser exhaust fan error
Remedy: Is the fan connector connected normally? Does this error recur?
Re-connect it normally. Replace the fan motor. Replace the PU board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie