Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1022 — Trang 2/13

Code: 197

Description: DFGATE error
The DFGEATE signal has already been asserted at the original scan.
Causes: • ADF interface cable defective • SBCU board defective • Mismatched firmware between the SBCU board and ADF

Code: 198

Description: Memory address error
The IPU board does not receive the memory address from the controller board.
Causes: • Mismatched firmware between the SBCU board and controller board • Controller defective • SBCU defective • IPU board defective

Code: 199

Description: DF scanning finish error
The original does not finish scanning with in 1 minute
Causes: • ADF interface cable defective • SBCU board defective • Mismatched firmware between the SBCU board and ADF

Code: 302

Description: Charge roller current leak
A charge roller current leak signal is detected.
Causes: • Charge roller damaged • Charge high voltage supply board defective • Poor connection of the PCU

Code: 320

Description: Polygon motor error
The polygon motor does not reach its operating speed within 10 seconds after the polygon motor on signal, or the lock signal is not detected for more than 200 ms continuously during operation.
Causes: • Polygon mirror motor defective • Poor connection between the polygon mirror motor driver and the SBCU board • SBCU board defective

Code: 322

Description: Laser synchronization error
The main scan synchronization detector board cannot detect the laser synchronization signal for more than 10 consecutive 50 ms intervals.
Causes: • Poor connection between the laser synchronization detector board and the SBCU board • Laser synchronization detector board out of position • Laser synchronization detector board defective • SBCU board defective • LD unit defective

Code: 323

Description: LD drive current over
The LD drive board applies more than 100 mA to the LD.
Causes: • LD unit defective (not enough power, due to aging) • Poor connection between the LD unit and the SBCU board • SBCU board defective

Code: 390

Description: TD sensor error
The TD sensor outputs less than 0.5V or more than 4.0V 10 times consecutively during copying.
Causes: • TD sensor abnormal • Poor connection of the PCU
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie