Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1032

Code: 101

Description: Exposure lamp error
The standard white level was not detected properly when scanning the white plate.
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
The scanner home position sensor does not detect the on condition during initialization or copying.
Causes: • Scanner drive motor defective • Scanner motor defective • Harness between SBCU and scanner drive motor disconnected • Harness between SBCU and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SBCU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
The scanner home position sensor does not detect the off condition during initialization.
Causes: • SIB or scanner drive motor defective • Scanner motor defective • Harness between SBCU and scanner drive motor disconnected • Harness between SBCU and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SBCU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 144

Description: SBU connection error
The IPU does not detect the SBU connection signal.
Causes: Cable between SBU and IPU board disconnected.

Code: 192

Description: Automatic SBU adjustment error
An error is detected during automatic SBU adjustment (SP4-428)
Causes: • SBU defective • SBCU board defective • Exposure lamp stabilizer defective • Exposure lamp defective • Dirty white plate

Code: 193

Description: Image transfer error
The IPU board does not finish within 1 minute after the image data has been transferred to the controller board.
Causes: • IPU board defective • Controller board defective • Video controller defective

Code: 195

Description: DFGATE assert error
The DFGATE signal does not assert within 30 seconds after the original has been scanned.
Causes: • ADF interface cable defective • SBCU board defective • Mismatched firmware between the SBCU board and ADF

Code: 196

Description: DFGATE negate error
The DFGATE signal does not negate within 1 minute after the DFGATE has been asserted.
Causes: • ADF interface cable defective • SBCU board defective • Mismatched firmware between the SBCU board and ADF
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie