Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1050 — Trang 6/18

Code: SC352

Description: ID sensor error 3
For 2 s during the ID sensor pattern check, the ID sensor pattern edge voltage is not 2.5V.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • Charge or development power pack defective • Dirty ID sensor • Defect at the ID sensor pattern writing area of the drum

Code: SC353

Description: ID sensor error 4
One of the following ID sensor output voltages is detected at ID sensor initialization. 1) Vsg < 4.0V when the maximum PWM input (255) is applied to the ID sensor. 2) Vsg . 4.0V when the minimum PWM input (0) is applied to the ID sensor.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • Charge or development power pack defective • Dirty ID sensor • Defect at the ID sensor pattern writing area of the drum

Code: SC354

Description: ID sensor error 5
Vsg falls out of the adjustment target (4.0 ± 0.2V) during Vsg checking.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • Charge or development power pack defective • Dirty ID sensor • Defect at the ID sensor pattern writing area of the drum

Code: SC360

Description: Hard disk detection error 1
When the main switch turns on, the machine does not detect the connection signal from the HDD.
Causes: • Poor connection between the HDD and BICU • Poor connection on the dc power connector to the HDD • HDD defective • BICU defective

Code: SC362

Description: Hard disk detection error 2
When the power switch on the operation panel turns on, the machine does not detect the connection signal from the HDD.
Causes: • Poor connection between the HDD and BICU • Poor connection on the dc power connector to the HDD • HDD defective • BICU defective

Code: SC364

Description: Hard disk drive errorThe image data stored in the HDD cannot be output properly.
Causes: • When this SC occurs only once, this problem will be solved after turning the main power switch off and on. • When this SC occurs while performing SP4-911-1 (HDD media check), it can be cured by doing SP4-911-2 (HDD formatting). • HDD defective

Code: SC366

Description: Hard disk bad sector maximum
The number of bad sectors on the HDD is over the maximum number.
Causes: • HDD defective • NVRAM defective

Code: SC367

Description: Hard disk (HDD:R) bad sector maximum
The number of bad sectors on the HDD is over the maximum number.
Causes: • HDD defective • NVRAM defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie