Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1105 — Trang 11/18

Code: SC541

Description: Fusing thermistor open
The fusing temperature detected by the thermistor is below 7°C for 35 seconds.
Causes: • Fusing thermistor defective or out of position • Poor thermistor terminal connection

Code: SC542

Description: Fusing temperature warming-up error
The fusing temperature does not reach the fusing standby temperature within 5 minutes after the main power switch is turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Fusing thermofuse open • BICU defective • Power supply board defective • Poor fusing unit connection

Code: SC543

Description: Fusing overheat error 1 (software)
A fusing temperature of over 230°C is detected for 5 seconds by the fusing thermistor.
Causes: • Fusing thermistor defective • BICU defective • I/O board (IOB) defective

Code: SC544

Description: Fusing overheat error 1 (hardware)
The BICU detects an overheat error even if the protection in the software does not work.
Causes: • Fusing thermistor defective • BICU defective • I/O board defective

Code: SC545

Description: Fusing overheat error 2
The fusing lamp stays on at full power for 45 seconds while in the stand-by condition after warming-up is completed.
Causes: • Fusing thermistor out of position

Code: SC546

Description: Fusing ready temperature malfunction
• A change in the fusing temperature by 20°C or more compared with the temperature of 1 second ago occurs 2 times consecutively. • A change in the fusing temperature by 20°C or more compared with the temperature of 1 second ago occurs 3 times consecutively for 1 minute.
Causes: • Poor connection on the thermistor • Poor connection on the fusing unit connector

Code: SC547

Description: Zero cross signal malfunction
• When the main switch is on, the frequency measured by the number of zero cross signals for 500 ms is larger than 66Hz or smaller than 45Hz. • It is measured 3 times consecutively for 500 ms that the interval between a zero cross signal and the next one is 7.5 ms or shorter.
Causes: • Power supply unit defective • Noise on the ac power line

Code: SC590

Description: Toner collection motor error
The toner collection motor sensor output does not change for 3 seconds while the toner collection motor is on.
Causes: • Toner collection motor defective • Too much load on the drive mechanism • Poor toner collection motor connector connection • IOB defective • Toner collection motor sensor defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie