Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1224C — Trang 4/17

Code: 410

Description: 2nd transfer (paper transfer) electric leakage (+)
Paper transfer starts. → The positive (+) output is at the minimum PWM duty value. → The returning voltage stays at 2.7 V or more for 60 milliseconds.
Causes: • Short circuit in the paper transfer unit • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 411

Description: 2nd transfer (paper transfer) electric leakage (–)
Paper transfer starts. → The negative (–) output is at the minimum PWM duty value. → The returning voltage stays at 4.5 V or more for 60 milliseconds.
Causes: • Short circuit in the paper transfer unit • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 412

Description: 2nd transfer (paper transfer) disconnection (+)
Paper transfer starts. → The positive (+) output is at the maximum PWM duty value for 60 milliseconds.
Causes: • Right cover not closed • Defective transfer roller contact mechanism • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 420

Description: Discharge error (fusing bias)
The discharge circuit is operating at the maximum PWM duty value for 60 milliseconds.
Causes: • Fusing bias short circuit • Scratched fusing belt • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 421

Description: Discharge plate error
During discharging, the leakage detection signal is low for 60 milliseconds.
Causes: • Short circuit in the discharge plate • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 430

Description: Transfer belt cleaning error
• Cleaning is operating at the maximum PWM duty value for 60 milliseconds.
Causes: • Short circuit in the transfer belt cleaning unit • Defective high voltage supply board • Defective harness (BICU -high voltage supply board)

Code: 440

Description: Main motor error
• The main motor starts or changes speed. → The lock signal does not continue for 1 second within 3 seconds. • The main motor starts. → The lock signal is detected and operation proceeds normally. → The lock signal is interrupted for 1 second.
Causes: • Defective main motor • Too much load of the main motor drive

Code: 460

Description: Temperature sensor error
The output is 4.5 V (or higher) or 0.3 V (or lower) for 12 seconds.
Causes: • Defective temp./ humidity sensor • Defective circuit • Defective connector
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie