Description: 4th paper tray lift motor malfunction (optional paper tray unit)
Causes: • Paper lift sensor connection loose, disconnected, or damaged • Paper lift sensor defective • Tray lift motor connection loose, disconnected, or damaged • Tray lift motor defective • Obstruction that causes overload on the drive mechanism
Description: Paper tray motor lock (optional paper tray unit)
A motor lock signal is not detected for more than 1.5 s or the lock signal is not detected for more than 1.0 s during rotation.
Causes: • Paper tray motor connection loose, disconnected, or damaged • Paper tray motor defective • Obstruction that causes overload on the drive mechanism
Description: LCT rear fence drive error
The return position sensor is not activated after the rear fence drive motor has been on to lower the tandem tray for 8 seconds.
Causes: • Rear fence motor connection loose, disconnected, or damaged • Rear fence motor defective • Return position sensor connector loose, disconnected, or damaged • Return position sensor defective • Obstruction that causes overload on the drive mechanism
Description: LCT side fence drive error
The side fence positioning sensor is not activated for more 3 seconds when the paper stack in the left tray is moved to the right tray. The side fence close sensor is not activated for more 3 seconds after moving the paper stack to the right tray.
Causes: • Obstruction that causes overload on the drive mechanism • Side fence motor disconnected or defective • Side fence position sensor disconnected or defective • Side fence close sensor disconnected or defective
Description: LCT lower limit error
The lower limit sensor does not activate within 8 seconds after the tray has been lowered.
Causes: • Tray lift motor defective • Poor connection of the tray lift motor • Lower limit sensor disconnected or defective • Obstruction that causes overload on the drive mechanism.
Description: Fusing thermistor open
The fusing temperature did not increase 12 °C at the center or ends of the hot roller within 2 seconds after two checks from the time the fusing lamps turned on.
Causes: • Fusing thermistor out of its position because of incorrect installation • Fusing thermistor disconnected or defective • Power supply not within rated range (15% or more below rating)
Description: Fusing temperature warm-up error
The fusing temperature does not reach the standby temperature within 20 seconds after the main switch is turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp disconnected • Fusing thermostat open
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.