Description: Fusing overheat error 2
• A fusing temperature over 250°C is detected by the fusing temperature monitor circuit in the SBCU board. • The power was interrupted for more than 0.3 sec.
Causes: • TRIAC short on PSU (PSU defective) • SBCU board defective • Fusing thermistor defective • Voltage of power supply unstable
Description: Fusing overheat error 3
After warmup, the hot roller attained full operating temperature and maintained this temperature for 10 sec. without the hot roller rotating.
Causes: • Hot roller thermistor is out of its position because of incorrect installation