Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3030 — Trang 10/17

Code: 730

Description: Finisher stapler motor error -1000-sheet Finisher B408
The stapler does not return to its home position within a certain time after the stapler motor turned on. -or-The stapler H.P sensor does not activate within a certain time after the stapler motor turned on.
Causes: • Stapler motor defective • Stapler H.P sensor defective • Poor stapler motor connection

Code: 731

Description: Finisher motor error
The meaning of this SC error depends on which finisher is installed. 1000-sheet Finisher B408 Exit guide plate motor error. The exit guide plate open sensor or exit guide plate HP sensor does not activate within a certain time after the exit guide plate motor turned on. (1000-sheet finisher) 500-sheet Finisher B442 Output tray motor error. The tray upper limit sensor does not activate within a certain time after the shift motor turned on. (500-sheet finisher)
Causes: 1000-sheet Finisher • Exit guide plate motor defective • Exit guide plate HP sensor defective • Exit guide plate open sensor defective 500-sheet Finisher • Output tray motor defective • Tray upper limit sensor defective

Code: 732

Description: Finisher shift motor error - 1000-sheet Finisher B408
Roller shift does not finish within a certain time after the shift motor turned on.
Causes: • Shift motor defective • Shift tray HP sensor defective

Code: 770

Description: Shift tray shift motor error
During a shift operation the sensor state did not change (off to on, or on to off) within 2.4 sec.
Causes: • Shift sensor defective • Shift motor defective

Code: 791

Description: Bridge communication error
The machine cannot communicate with the finisher with the bridge unit installed.
Causes: • Poor connection between the finisher and mainframe • Harness damaged or defective

Code: 792

Description: Finisher connection error
The machine cannot communicate with the finisher with the bridge unit installed.
Causes: • Finisher connection defective

Code: 793

Description: Interchange communication error
The machine cannot communicate with the interchange unit properly when the duplex unit is installed.
Causes: • Interchange unit installed incorrectly • Interchange unit connection loose, disconnected, or damaged • Interchange unit harness damaged

Code: 800

Description: Startup without video output end error (K)
Video transfer to the engine is started, but the engine did not issue a video transmission end command within the specified time.
Causes: • Controller board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie