Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3224C — Trang 6/17

Code: 541

Description: Thermistor disconnection (heating roller)
The fusing unit starts warm up to the print ready temperature. The temperature does not reach 0°C for 10 seconds.
Causes: • Defective thermistor • Thermistor loose connection • Defective connector

Code: 542

Description: Fusing warm-up timeout (heating roller)
The main switch is turned on or a cover is closed. The heating roller does not reach the warm-up temperature within 4 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (loose thermistor connection, fusing - drawer loose connection)

Code: 543

Description: Overheat error (heating roller)
The heating roller thermistor detects 220°C for 5 seconds.
Causes: • Short circuit • Defective BICU board • Defective PSU

Code: 544

Description: Overheat error (heating roller)
The heating roller thermistor detects 230 °C.
Causes: • Short circuit • Defective BICU board • Defective PSU

Code: 545

Description: Full power error (heating roller)
Fusing unit warm-up is complete. The heating roller stops turning. The heating roller lamp keeps outputting the maximum power for 12 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 546

Description: Unstable temperature (heating roller)
The heating roller thermistor detects unstable temperature increases or decreases within 60 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 547

Description: Zero cross error
The main power is turned on and the machine checks how many zero-cross signals are generated during 500 ms. If the number of zero-cross signal generated is more than 66 or less than 45 and when this condition is detected 10 consecutive times, this code is displayed.
Causes: • Replace the PSU. • FU12 is open.

Code: 551

Description: Thermistor disconnection (pressure roller)
The pressure roller thermistor detects 7°C or lower for 80 seconds.
Causes: • Thermistor loose connection • Defective harness • Defective connector
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie