Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio AP4500 — Trang 3/10

Code: SC350-4

Description: ID Sensor Error 4 Definition [D] One of the following ID sensor output voltages is detected at ID sensor initialization. 1) Vsg < 4.0 V when the maximum PWM input (255) is applied to the ID sensor. 2) Vsg>=4.0 V when the minimum PWM input (0) is applied to the ID sensor.
Causes: · ID sensor defective · ID sensor connector defective · Poor ID sensor connector connection · I/O board (IOB) defective · High voltage supply board defective · Dirty ID sensor · Defect at the ID sensor pattern writing area of the drum

Code: SC350-5

Description: ID Sensor Error 5 Definition [D] Vsg falls out of the adjustment target (4.0 ± 0.2 V) during Vsg checking
Causes: · ID sensor defective · ID sensor connector defective · Poor ID sensor connector connection · I/O board (IOB) defective · High voltage supply board defective · Dirty ID sensor · Defect at the ID sensor pattern writing area of the drum

Code: SC361

Description: Hard Disk Drive Error Definition [B] The image data stored in the HDD cannot be output properly.
Causes: NOTE: If the error was caused by a temporary condition, this problem will be solved after turning the main switch off and on. · HDD defective

Code: SC362

Description: IMAC (Image Compression IC) Error Definition [B] An error occurs during image processing in the IMAC, which handles image compression and image data transmission.
Causes: · BICU defective

Code: SC365

Description: Image Storage Address Error Definition [B] The BICU receives an image data output request signal for data that is not stored in memory.
Causes: · BICU defective

Code: SC390-1

Description: TD Sensor Error 1 Definition [B] The TD sensor output voltage is less than 0.5 V or more than 4.0 V 10 times consecutively during printing.
Causes: · TD sensor abnormal · Poor connection between the TD sensor and the I/O board (IOB) · I/O board (IOB) defective

Code: SC390-2

Description: TD Sensor Error 2 Definition [B] The TD sensor output voltage is less than 1.8 V or more than 4.8 V during TD sensor initial setting.
Causes: · TD sensor abnormal · No developer in the development unit

Code: SC391

Description: Development Bias Leak Definition [B] A development bias leak signal is detected.
Causes: · Poor connection between the development bias terminal and the high voltage supply board · High voltage supply board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie