Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP1900 — Trang 4/5

Code: 552

Description: Fusing temperature warm-up error (rear)
The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
Causes: - Fusing thermistor defective or out of position
- Fusing lamp open
- Power supply board defective

Code: 553

Description: Fusing overheat error (rear)
The fusing temperature is over 230°C for 1 second (detected by the thermistor).
Causes: - Fusing thermistor defective
- Power supply board defective

Code: 555

Description: Fusing lamp overheat error (rear)
After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 20 consecutive seconds.
Causes: - Fusing thermistor defective or out of position
- Power supply board defective

Code: 556

Description: Unstable fusing temperature (rear)
The fusing temperature varies 50° C or more within 1 second, and this occurs 2 consecutive times.
Causes: - Thermistor defective or out of position
- Power supply unit defective

Code: 559

Description: Jam error detected 3 times in succession
The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP 1159 1 is set to 'on'. The default is 'off'.
Causes: - Paper jams can occur for the following reasons.
- Dampness
- Paper curl
- Incorrect paper setting in the paper tray
- Stripper pawls coming apart

Code: 590

Description: Left exhaust fan motor error
The CPU detects an exhaust fan lock signal for more than 5 seconds.
Causes: - Loose connection of the exhaust fan motor
- Too much load on the motor drive

Code: 621

Description: ADF connection error
An incorrect ADF (an ADF for some other copier) is detected.
Causes: ADF incorrect (The ADF for B039/B040/B043 or B121/B122/B123 is installed on this machine.)

Code: 760

Description: ADF gate abnormal 1
The ADF Gate signal line between the ADF main board and the BICU is disconnected.
Causes: - ADF main board defective
- Input/output board defective
- Poor connection (ADF Gate line) between the
- ADF main board and the BICU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie