Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP3010 — Trang 9/17

Code: 720

Description: Finisher motor error
The meaning of this SC error depends on which finisher is installed. 500-sheet Finisher B442 There is a problem with the upper transport motor.1000-sheet Finisher B408 There is a problem with the registration motor.
Causes: • The motor connectors are loose, disconnected or damaged. • The motor is defective

Code: 721

Description: Lower transport motor error - 1000sheet Finisher B408
There is a problem with the lower transport motor.
Causes: • The motor connectors are loose, disconnected or damaged. • The motor is defective

Code: 722

Description: Finisher jogger motor error - 1000-sheet Finisher B408
The finisher jogger H.P sensor remains de-activated for a certain time when returning to home position. The finisher jogger H.P sensor remains activated for a certain time when moving away from home position.
Causes: • Jogger H.P sensor disconnected or defective • Jogger motor connectors loose, disconnected, or damaged • Jogger motor defective

Code: 724

Description: Finisher staple hammer motor error - 1000-sheet Finisher B408
Stapling does not finish within 600 ms after the staple hammer motor turned on.
Causes: • Staple jam • Stapler overload caused by trying to staple too many sheets • Staple hammer motor defective

Code: 725

Description: Finisher stack feed-out motor error - 1000-sheet Finisher B408
The stack feed-out belt H.P sensor does not activate within a certain time after the stack feed-out motor turned on.
Causes: • Stack feed-out H.P sensor defective • Stack feed-out motor defective

Code: 726

Description: Finisher lift motor error
The stack height sensor does not activate within a certain time after the shift tray lift motor turned on. Note: This error applies to the 500-sheet and the 1000-sheet finisher.
Causes: • Shift tray lift motor defective • Stack height sensor defective

Code: 727

Description: Finisher staple hammer motor error - 500-sheet Finisher B442
Stapling does not finish within a certain time after staple hammer motor turned on.
Causes: • Staple jam • Stapler overload caused by trying to staple too many sheets • Staple hammer motor defective

Code: 728

Description: Finisher exit motor/paper stack height error
The meaning of this SC error depends on which finisher is installed. 1000-sheet Finisher B408 Exit motor error. 500-sheet Finisher B442 Stack height sensor error. The stack height detection lever does not return to its home position before going to detect the stack height.
Causes: Exit motor error (B408) • Exit motor connector loose, disconnected, or damaged • Exit motor defective Stack height sensor error (B442) • Stack height lever solenoid defective • Stack height sensor defective • Lever sensor defective • Main control board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie