• Code: SC761-04
• Description: Protection Device Intercept Error 24V Fuse blowout occurs due to over current during power injection (output detected for longer than 2 seconds).
• Causes: • Over current of bridge unit motor • Over current due to short-circuit in PCB
• Remedy: • Replace the bridge unit • Replace the PCB.

• Code: SC780-01
• Description: Bank 1 (Upper optional paper tray) Protection Device Intercept Error When original source of 5V power supply is ON, protection device intercept of 24V power system is detected.
• Causes: In 24V power supply system: • Motor defective • Solenoid defective • Harness short- circuit
• Remedy: • Replace the PCB • Replace the short-circuited part (harness, motor, solenoid)

• Code: SC781-01
• Description: Bank 2 (Lower optional paper tray) Protection Device Intercept Error When original source of 5V power supply is ON, protection device intercept of 24V power system is detected.
• Causes: In 24V power supply system: • Motor defective • Solenoid defective • Harness short- circuit
• Remedy: • Replace the PCB • Replace the short-circuited part (harness, motor, solenoid)

• Code: SC791-00
• Description: No Bridge Unit when Finisher is Present. When power supply is switched on or paper is transported, finisher set is detected but bridge unit set is not detected. (during internal finisher connection, not detected)
• Causes: • Bridge unit not attached • Bridge unit defective
• Remedy: • Reset the bridge unit • Turn the power off/on

• Code: SC792-00
• Description: No Finisher, Bridge Unit Provided When a machine which has a bridge unit is powered on, no finisher is detected
• Causes: • Finisher connector set fault • In a machine which has a bridge unit connected, a finisher is not fitted • Finisher defective
• Remedy: Connect finisher or disconnect bridge unit, and turn the power off/on

• Code: SC816
• Description: Energy save I/O subsystem error
• Causes: • Energy save I/O subsystem defective • Energy save I/O subsystem detected a controller board error (non-response). • Error was detected during preparation for transition to STR.
• Remedy: • Turn the main power off/on. • Replace the controller board.

• Code: SC817-00
• Description: Monitor error: File detection / Digital signature error • Bootloader cannot read any of diagnostic module, kernel, or root filesystem. • In a bootloader SD card, the digital signature cheking for any of diagnostic module, kernel, or root filesystem is failed.
• Causes: • Any of the following items does not exist or is broken: OS Flash ROM, Diagnostic module in SD card, Kernel, Root filesystem • Any of the following items is revised fraudulently: Diagnostic module in SD card, Kernel, Root filesystem
• Remedy: • ROM update for controller system • Use another booting SD card having a valid digital signature

• Code: SC818-00
• Description: Watchdog timer error The system program fell into a bus-hold state or an endless loop of the program interruption occurred, causing other process to stop.
• Causes: • System program defective • Controller board defective • Optional board defective
• Remedy: • Turn the main power off/on. • Replace the controller board.