Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP6002 — Trang 3/33

Code: 188

Description: CIS white level error The shading data peak detected from the CIS is abnormal.
Causes: • CIS defective

Code: 189

Description: CIS gray balance adjustment error The adjustment error occurs during the test after adjusting the gray balance.
Causes: • CIS defective

Code: 195

Description: Machine serial number error The number registered for the machine serial number does not match.
Causes: 1. Confirm the correct serial number of the machine in the specifications. Important: When SC195 occurs, the serial number must be input. Contact your technical supervisor.

Code: 202

Description: Polygon mirror motor error 1: Timeout at ON The polygon mirror motor unit did not enter "Ready" status within 20 sec. after the motor was turned on,
Causes: • The polygon mirror motor PCB connector is loose, broken, or defective • Polygon mirror motor PCB defective • Polygon mirror motor defective • IPU defective

Code: 203

Description: Polygon mirror motor error 2: Timeout at OFF The polygon mirror motor did not leave "Ready" within 3 sec. after the motor was switched off. (The XSCRDY signal did not go HIGH (inactive) within 3 sec.)
Causes: • The polygon mirror motor PCB connector is loose, broken, or defective • Polygon mirror motor PCB defective • Polygon mirror motor defective • IPU defective

Code: 204

Description: Polygon mirror motor error 3: XSCRDY signal error The polygon mirror motor "Ready" signal goes inactive (HIGH) while images are being produced or the synchronization signal is being output.
Causes: • Polygon mirror motor PCB connector loose, broken, defective • Polygon mirror motor PCB defective • Polygon mirror motor defective

Code: 205

Description: Polygon mirror motor error 4: Unstable timeout The "Ready" signal (XSCRDY) was detected as unstable for more than 20 sec. while the polygon mirror motor was operating at normal speed.
Causes: • Electrical noise on the line with the motor signals • Polygon mirror motor PCB connector loose, broken, defective • Polygon mirror motor PCB defective • IPU defective

Code: 220

Description: Laser synchronization detection error The 1st laser synchronization detection unit could not detect the line synchronization signal (DETP0) within 500 ms while the polygon mirror motor was operating at normal speed. Note: The unit polls for the signal every 50 ms. This SC is issued after the 10th attempt fails to detect the signal.
Causes: • Laser synchronization board connector loose, broken, defective • Laser synchronization detection board is not installed correctly (out of alignment) • Laser synchronization board defective • IPU defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie