Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP6002 — Trang 10/33

Code: 542-003

Description: Fusing temperature warm-up error 3: Center themistor The center thermistor that touches the hot roller determined that the hot roller failed to reach 100 within the prescribed time.
Causes: • Fusing lamp disconnected • Thermistor warped, out of position • Thermostat has opened

Code: 543

Description: Fusing lamp overheat error 1 (software) Central thermistor detected a temperature of 240°C at the center of the hot roller. Fusing temperature control software error
Causes: • PSU defective • IOB defective • BICU defective

Code: 544

Description: Fusing lamp overheat error 1: Hardware The center thermistor or an end thermistor detected a temperature of 250°C on the hot roller.
Causes: • PSU defective • IOB defective • BICU defective

Code: 545

Description: Fusing lamp overheat error 2: Center lamp After hot roller reaches warm-up temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 s. duration) while the hot roller was not rotating.
Causes: • Thermistor damaged, or out of position • Fusing lamp disconnected

Code: 547-01

Description: Zero cross signal error 1: Fusing relay At power on and with the fusing relay off, 3 samplings detected that the zero cross was not normal.
Causes: • Fusing relay short • Fusing relay drive circuit defective

Code: 547-02

Description: Zero cross signal error 2: Fusing relay No zero cross signal was detected within 3 sec. after power on or after closing the front door.
Causes: • Fusing relay short • Fusing relay drive circuit defective

Code: 547-03

Description: Zero cross signal error 2: Unstable power supply After 11 samplings the power supply was not within 50 to 60 Hz, indicating that the power supply is not stable.
Causes: • Check power source with local supplier

Code: 551

Description: Fusing thermistor error 1: End thermistor The end thermistor (contact type) was less than 0C (32F) for more than 7 seconds.
Causes: • Thermistor connector loose, broken, defective • Thermistor incorrectly installed or loose
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie