Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC2530 — Trang 15/23

Code: 682

Description: Memory chip at TD sensor: Communication error
Retry of memory chip communication fails three times after the machine has detected the memory chip communication error.
Causes: • Damaged memory chip data • Disconnected inter face • No memory chip on the development unit • Noise
Remedy: 1. Replace the development unit. 2. Replace the PCDU.

Code: 683

Description: RFID: Unit check error
The machine gets RFID communication error even the toner cartridges have not been installed in the machine.
Causes: Caused by noise
Remedy: Turn the main power switch off and on.

Code: 687

Description: Memory address command error
The BICU does not receive a memory address command from the controller 120 seconds after paper is in the position for registration.
Causes: • Loose connection • Defective controller • Defective BICU
Remedy: 1. Check if the controller is firmly connected to the BCU. 2. Update the firmware of the i-controller. 3. Replace the HDD. 4. Update the firmware of the BCU. 5. Replace the BCU. 6. Replace the i-controller.

Code: 690

Description: GAVD communication error
• The I2C bus device ID is not identified during initialization. • A device-status error occurs during I2C bus communication. • The I2C bus communication is not established due to an error other than a buffer shortage.
Causes: • Loose connection • Defective BICU • Defective LD controller board
Remedy: 1. Turn the main switch off and on. 2. Check the cable connection. 3. Replace the laser unit. 4. Replace the BCU board.

Code: 730

Description: Shift tray motor error
The shift tray HP sensor does not activate within 1.86 seconds after the shift tray motor starts to move at power on or copying. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Defective shift tray motor • Defective shift tray HP sensor.
Remedy: Replace the shift tray motor.

Code: 740

Description: Finisher stapler motor error (D038/D041)
The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Staple jam • Motor overload • Defective stapler motor • Defective stapler safety sensor
Remedy: 1. Check the connections and cables for the components mentioned above. 2. Replace the stapler unit 3. Replace the finisher main board.

Code: 742

Description: Finisher stapler movement motor error (D038/D041)
Causes: • Motor overload • Loose connection of the stapler unit HP sensor • Loose connection of the stapler unit movement motor • Defective stapler unit HP sensor • Defective stapler movement motor
Remedy: 1. Check the connection of the stapler movement motor. 2. Check the connection of the stapler unit HP sensor. 3. Replace the stapler unit HP sensor. 4. Replace the stapler unit movement motor.

Code: 750

Description: Tray lift motor error (D038/D041)
Causes: • Motor overload • Loose connection of the tray lift motor • Defective tray lift motor
Remedy: 1. Check the connections to the tray lift motor. 2. Replace the tray lift motor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie