Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC401SP — Trang 2/25

Code: 195

Description: Serial Number Mismatch • Serial number stored in the memory does not have the correct code.
Causes: • EEPROM defective • BCU replaced without original EEPROM
Remedy: • Check the serial number with SP5-811-002. • If the stored serial number is incorrect, contact your supervisor.

Code: 202

Description: Polygon motor error 1: ON timeout The polygon mirror motor does not reach the targeted operating speed within the specified time after turning on or changing speed
Causes: • Defective or disconnected harness to polygon motor driver board • Defective polygon motor driver board • Defective polygon motor • Defective IPU
Remedy: • Replace the laser unit. • Replace the harness. • Replace the IPU.

Code: 203

Description: Polygon motor error 2: OFF timeout The polygon mirror motor does leave the READY status within 3 seconds after the polygon motor switches off.
Causes: • Disconnected or defective harness to polygon motor driver board • Defective polygon motor driver board • Defective laser unit • Defective IPU
Remedy: • Check or replace the harness. • Replace the laser unit. • Replace the IPU.

Code: 204

Description: Polygon motor error 3: XSCRDY signal error The SCRDY_N signal goes HIGH (inactive) while the laser diode is firing.
Causes: • Disconnected or defective harness to polygon motor driver board • Defective polygon motor • Defective polygon motor driver board • Defective IPU
Remedy: • Check or replace the harness. • Replace the laser unit. • Replace the IPU

Code: 220-01

Description: Laser synchronizing detection error: start position [K]: LD0. The laser synchronizing detection signal for the start position of the LDB [K], [Y] is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally.
Causes: • Disconnected cable from the laser synchronizing detection unit or defective connection • Defective laser synchronizing detector • Defective LDB • Defective IPU
Remedy: • Check the connectors. • Replace the laser unit. • Replace the IPU.

Code: 220-04

Description: Laser synchronizing detection error: start position [Y]: LD0. The laser synchronizing detection signal for the start position of the LDB [K], [Y] is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally.
Causes: • Disconnected cable from the laser synchronizing detection unit or defective connection • Defective laser synchronizing detector • Defective LDB • Defective IPU
Remedy: • Check the connectors. • Replace the laser unit. • Replace the IPU.

Code: 230-01

Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K].
Causes: • Poor connection between controller and IPU. • Defective IPU
Remedy: • Check the connection between the controller board and the IPU. • Replace the IPU.

Code: 230-02

Description: FGATE ON error: C
Causes: The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [C].
Remedy: • Check the connection between the controller board and the IPU. • Replace the IPU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie