Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPW2400 — Trang 10/11

Code: 910 ... 914

Description: 910 B External controller error 1 911 B External controller error 2 912 B External controller error 3 913 B External controller error 4 914 B External controller error 5
Causes: The external controller alerted the machine about an error.
Remedy: • Refer to the instructions for the external controller

Code: 919

Description: External controller error 6 While EAC (External Application Converter), the conversion module, was operating normally, the receipt of a power line interrupt signal from the FLUTE serial driver was detected, or BREAK signal from the other station was detected.
Causes: • Controller RW3600 power outtage • Controller RW3600 rebooted • Connection to Controller RW3600 loose
Remedy:

Code: 920

Description: Printer error 1 An internal application error was detected and operation cannot continue.
Causes: • Software defective • Turn the machine power off/on, or change the controller firmware • Insufficient memory
Remedy:

Code: 921

Description: Printer Error 2. When the printer application started, the font designated for use could not be found on the SD card.
Causes: • The font is not on the SD card
Remedy:

Code: 953

Description: Scanner start error The job was ready to start with the selected image processing mode, but the program did not receive a start signal from the IPU.
Causes: • Firmware bug • Update the scanner firmware • IPU defective
Remedy:

Code: 954

Description: Printer Image Setting Error The settings that are required for image processing using the printer controller are not sent from the IPU.
Causes: • Firmware bug • IPU defective
Remedy:

Code: 955

Description: Memory Setting Error The settings that are required for image processing using the memory are not sent from the IPU.
Causes: • Firmware bug • Hard disk unit defective • Controller defective • MCU defective • IPU defective
Remedy:

Code: 964

Description: Scanner Start Error During scanned image processing, another command to start scanning was received.
Causes: • Scanner firmware defective • Update scanner firmware
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie