Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPW5100 — Trang 4/15

Code: SC531

Description: Fusing drive motor error The fusing drive motor lock signal remained HIGH for 5 sec.
Causes: • Fusing motor drive mechanism overloaded. • Motor defective
Remedy:

Code: SC532

Description: Left fusing pressure motor home position error 1 The left pressure motor did not arrive at the home position within 23 sec. after the left pressure motor started.
Causes: • Left fusing pressure motor home position sensor loose, broken, defective. • Sensor defective. • Motor drive mechanism overloaded • Motor defective.
Remedy:

Code: SC533

Description: Left fusing pressure motor home position error 2 The left pressure motor remained at the home position for 3 sec. after the motor switched on.
Causes: • Left fusing pressure motor home position sensor loose, broken, defective. • Left fusing pressure motor drive mechanism overloaded • Sensor defective. • Motor defective.
Remedy:

Code: SC534

Description: Right fusing pressure motor home position error 1 The right pressure motor did not arrive at the home position 23 sec. after the right pressure motor switched on.
Causes: • Right fusing pressure motor home position sensor loose, broken, defective. • Right fusing pressure motor drive mechanism overloaded • Sensor defective. • Motor defective.
Remedy:

Code: SC535

Description: Right fusing pressure motor home position error 2 The right pressure motor remained at the home position 3 sec. after motor switched on.
Causes: • Right fusing pressure motor home position sensor loose, broken, defective. • Right fusing pressure motor drive mechanism overloaded • Sensor defective. • Motor defective.
Remedy:

Code: SC541

Description: Fusing thermistor open The fusing temperature detected by the thermistor remained below 5°C (41°F) for 30 sec.
Causes: • Thermistor cable disconnected, broken, defective • Thermistor defective
Remedy:

Code: SC542

Description: Fusing temperature warm-up error During warm-up after switching on the machine, or after opening and closing the machine, hot roller did not attain the ready temperature within 5 minutes (the temperature was detected below 3°C (37.4°F) 5 times within 5 sec.).
Causes: • Fusing lamp defective • Thermistor floating, out of position • Thermistor cable disconnected, broken • Fusing thermistor defective
Remedy:

Code: SC543

Description: Fusing overheat error 1: Software A fusing temperature of over 230°C (446°F) was detected for 2 sec.
Causes: • PSU defective • TRIAC short, IOB board defective • BCU board defective
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie