Code :

Code: SC833
Description: Self-diagnostic error 8: Engine I/F ASIC
Causes: 0F30 0F31 ASIC (Mandolin) for system control could not be detected. After the PCI configuration, the device ID for the ASIC could not be checked. 0F41 The read/write check done for resident RAM on the mother board could not be done correctly. 50B1 Could not initialize or read the bus connection. 50B2 Value of the SSCG register is incorrect. • Check for loose connections at MB (Mother Board) • Replace MB
Remedy:

Code: SC853
Description: Wireless LAN Error 1: Startup GW During machine start-up, the machine can access the board that holds the wireless LAN, but not the wireless LAN card.
Causes: • Wireless LAN card missing from slot
Remedy:

Code: SC854
Description: Wireless LAN Error 2: Operation
Causes: During machine start-up, the machine can access the board that holds the wireless LAN, but not the wireless LAN card. • Wireless LAN card missing from slot
Remedy:

Code: SC855
Description: Wireless LAN Error 3: Board Error GW During machine operation of the wireless connection, an error occurred on the wireless LAN board.
Causes: • Wireless LAN board not installed properly • Wireless LAN board defective
Remedy:

Code: SC856
Description: Wireless LAN error 5: Board Error GW An error was detected on the wireless LAN board.
Causes: • Wireless LAN board defective • PCI connector (to the mother board) loose
Remedy:

Code: SC858
Description: Serious data encryption error GW A serious error occurred during data encryption due to corruption of USB Flash or other data, or the presence of a magnetic field.
Causes: • Power the system off/on • If this does not solve the problem, replace the data encryption board
Remedy:

Code: SC859
Description: Data encryption HDD error
Causes: An error occurred while data encryption was in progress. • The update procedure for the data encryption key was started with no HDD installed in the main machine. • The machine was switched off while the data encryption key was being updated. • An HDD error occurred caused by the effect of spurious noise on the disk or harnesses.
Remedy: • Check all the HDD harness connection points • Initialize the HDD with SP5832 • Replace the HDD