Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP4210N — Trang 2/8

Code: 541

Description: Fusing thermistor error
The fusing temperature did not rise higher than 20C within 10 sec. after the main motor switched off. -or- The fusing temperature was detected lower than 0C for over 1 sec. after the power relay switched on.
Causes: Thermistor disconnected, defective. Fusing lamp disconnected, defective. Fuse blown. Power supply board defective. Fusing unit connected improperly

Code: 542

Description: Fusing temperature warm-up error
Just before reaching warm-up temperature, the fusing temperature did not rise above 80oC within 15.5 sec. after the power relay switched on.
Causes: Thermistor defective. Fusing lamp open. Fusing thermostat open. Power supply board Defective. Defective connection of the fusing unit

Code: 543

Description: Fusing overheat error – software
The fusing temperature was detected higher than 235C for longer than 200 ms.s
Causes: Fusing thermistor defective. Power supply board defective

Code: 544

Description: High temperature detection: Hard
The thermister detects a high temperature signal.
Causes: Defective thermister. Defective fusing unit, PSU, engine board

Code: 545

Description: Fusing lamp remains on
The fusing lamp remained on longer than 12 sec. after the fusing unit reached optimum temperature and the main motor switched off.
Causes: Fusing thermistor defective. Power supply board defective. Defective connection of the fusing unit

Code: 546

Description: Unstable fusing temperature Hard
During standby, the fusing temperature went below 60C twice or went above 60C three times within 500 ms.
Causes: Fusing thermistor defective. Power supply board defective. Defective connection of the fusing unit

Code: 547

Description: Zero cross signal error
Zero cross signals of wavelength 50-60 Hz were not detected within 5 sec after the fusing relay switched on. -or- Zero cross interrupts did not issue at the prescribed 3 sec. intervals.
Causes: Power supply board defective. Defective mains power supply condition

Code: 559

Description: Fusing unit jam
Three consecutive paper lag jams (paper failed to arrive) were detected in the fusing unit. -or- During printing of the 1st side during duplexing, the paper did not arrive at the duplex entrance sensor three times.
Causes: Fusing unit installed incorrectly. Fusing unit defective condition
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie